| Tools and Supplies to Install Siding Drip Edge | ||||
|---|---|---|---|---|
| 1 | Drip edge | |||
| 2 | Measuring tape | |||
| 3 | Chalk line | |||
| 4 | Circular saw | |||
| 5 | Saw blade for cutting metal | |||
| 6 | Tin snips | |||
| 7 | Drill | |||
| 8 | Metal drill bit | |||
| 9 | Hammer | |||
| 10 | Roofing nails | |||
| 11 | Roofing cement | |||
| 12 | Caulk gun | |||
| 13 | Silicone caulk | |||
| 14 | Safety glasses | |||
| 15 | Work gloves. | |||
Installing siding drip edge is an important step in ensuring that your home is protected from water damage. The drip edge is a small piece of metal that is installed at the edge of the roofline to help direct water away from the fascia board and prevent it from seeping into the walls of your home. Here is a step-by-step guide on how to install siding drip edge.
Step 1: Clean the Roofline
Before you begin installing the drip edge, it is important to clean the roofline thoroughly. Remove any debris or dirt that may be present on the roofline to ensure that the drip edge can be installed properly.
Step 2: Measure the Length of the Roofline
Measure the length of the roofline where you will be installing the drip edge. This will help you determine the amount of drip edge you will need to purchase.
Step 3: Cut the Drip Edge to Size
Using a pair of tin snips, cut the drip edge to the appropriate length. Be sure to wear gloves and eye protection when cutting the metal.
Step 4: Install the Drip Edge
Starting at one end of the roofline, place the drip edge under the first row of shingles. The drip edge should be positioned so that it extends over the edge of the roofline by approximately 1 inch. Use roofing nails to secure the drip edge in place. Be sure to nail the drip edge every 12 to 18 inches along the length of the roofline.
Step 5: Overlap the Drip Edge
When you reach the end of the roofline, overlap the drip edge by approximately 2 inches. This will help ensure that water is directed away from the fascia board and into the gutter system.
Step 6: Secure the Drip Edge
Once the drip edge has been installed, use a hammer to tap down any raised edges or corners. This will help prevent water from getting trapped under the drip edge and causing damage to your roofline.
In conclusion, installing siding drip edge is an important step in protecting your home from water damage. By following these simple steps, you can ensure that your home is properly protected and that your roofline remains in good condition for years to come.